O2 Lambda Sensor Angle Fitting 18mm Stainless

MG-IN-006
New product

10,00 €

More than 4 Items
In stock

- +

More info

The product is made of acid-proof steel.

Thanks to the use of recess in the construction of the socket, you can easily plug the socket into the pipe.

The assembly consists in drilling a hole with a diameter of 23mm in the place where we plan the placement of the probe. Next, we install a new socket in the hole, which thanks to the execution of the undercut will resist on the pipe wall. Then we weld the seat of the socket contact with the pipe.

Thanks to the use of stainless steel, we can be sure that our new nest will never corrode, and we will not have problems in the future to remove the probe from it.

The socket is universal, fits almost all lambda probes. It has a M18x1.5 thread

    14 other products in the same category:

    No products

    0,00 € Total products

    Prices are tax included

    Check out