AEM's F/IC-6 allows racers to retard ignition and deliver accurate amounts of fuel to aftermarket forced induction race engines with up to 6 cylinders without the need for outdated FMUs or "boost hiding" controllers. This system works parallel to the factory ECU on OBD-II-equipped race vehicles with non-factory forced induction systems with or without variable cam timing and prevents tuning limitations due to complex factory timing patterns.
- F/IC-6 works with aftermarket forced induction racecars up to 6 cylinders
- Ideal for non-factory forced induction vehicles with variable cam timing (VTEC, VVTi, MiVEC, etc)
- Will not affect climate controls, dash or other components on CAN-bus network
- USB powered for calibration changes when removed from vehicle
- 64kb internal data logging
| FEATURES |
F/IC-6 |
| Injector Channels |
6 |
| Advanced Injector Load Simulation & Filtering |
NO |
| Timing Channels (Cam + Crank) |
3 |
| High/Low Voltage Selectable MAG-Driver Outputs |
NO |
| TPS Input |
YES |
| MAP Sensor (Onboard) |
YES |
| MAP (0-5v Intercept) |
YES |
| Frequency Based Flow Meter Support |
NO |
| Speedometer Recalibrator |
NO |
| O2 Sensor Remapping |
YES |
| External AFR Input |
YES |
| Generic 0-5v Remappers |
2 |
| Boost Controller (Requires AEM 30-2400 Solenoid) |
NO |
| IAT Logging Input |
NO |
| PC Datalogging |
YES |
| Internal Logging Memory |
64 Kb |
| VTEC Output/Control/+12V Switched Output |
YES |
| MAG or HALL Sensor |
30-1910 |
| MAG Pickup Sensor. 80's-90's Disributed Honda |
30-1911 |
| MAG or HALL with Circuit Driver for Injector Load on Chrysler Vehicles |
30-1913 |
Lietuvių kalba 
English 
